Hi Martin I followed your new instructions but it still does not work. Here is what I did: I created the config file in ccs to have a UART connection and to bypass c28. If I now launch this new configuration in CCS and load my program onto the target, either RAM or Flash, and load symbols on the UART connection, I am able to see all variables updating in expressions view and on my Gui. Then I upload this config file to my Gui composer project as per your instructions. Auto Program is not checked. I also have a USB_UART communication setup. Then I run the Gui from the cloud. It tries to connect and then ends with a "Hardware not connected" message. This is also the same case if I Export the Gui to Stand-alone app and run it. I Only get a "Hardware not connected". I also configure the serial port in the Gui.
↧