Microcontrollers

↧

Forum Post: RE: MSPM0G3507: Flash operations Read,write, blank verify

April 1, 2025, 8:32 pm

Thankyou Pengfei, Will direct memcpy from the required flash address will work for read or do I have to go through the process of mentioned for read operations in sdk..?

View Article

Forum Post: RE: AM2634-Q1: Customer used AM2634 for HSM development issue?

April 1, 2025, 8:36 pm

Hi Nikhil, I have just successfully converted the SE mode with the OTP key writer generated by myself, and the process should be fine. The original conversion failure process is as follows: 1. Burn...

View Article

Forum Post: RE: CODECOMPOSER: Editor not finding the project Build Symbols

April 1, 2025, 9:41 pm

Hi Aitor, The CCS 20.1.1 release that Patrick mentioned is now available for download ( https://www.ti.com/tool/download/CCSTUDIO ). Can you try it out and see if it resolves the issues you are...

View Article

Forum Post: RE: TMS320F28388D: Implement the CPU Usage % mechanism for C28x CPUs

April 1, 2025, 9:52 pm

Hello, Please respond on this.

View Article

Forum Post: TMS320F28388S: UART SCI interrupt

April 1, 2025, 9:54 pm

Part Number: TMS320F28388S Tool/software: Hello, I am working on SCI-UART (TMS320F28388S) . taken example sci_ex2_loopback_interrupts from devicelib in that just commented loopback function but not...

View Article

Forum Post: RE: TMS570LC4357: Checking privilege mode of mcu

April 1, 2025, 9:56 pm

Hi LayEng, This is not controller TRM, it is cortex-R5 core TRM: Here is the Core TRM: e2e.ti.com/.../3000.DDI0460C_5F00_cortexr5_5F00_trm.pdf -- Thanks & regards, Jagadish.

View Article

Forum Post: RE: TMS320F28388D: Implement the CPU Usage % mechanism for C28x CPUs

April 1, 2025, 10:03 pm

Hi Rohit, Using the FreeRTOS vTaskGetRunTimeStats() API, you'll be able to get the CPU usage % of all the RTOS tasks, including the idle (this is measured w.r.t. a timebase set up by a timer running...

View Article

Forum Post: RE: TMS320F28388D: Implement the CPU Usage % mechanism for C28x CPUs

April 1, 2025, 10:06 pm

Hi Arnav, Regarding ERAD module for profiling, could you please share links to the documents, examples, etc. That will be very useful. Thanks Rohit

View Article

Forum Post: RE: RM57L843: EMIF_nWait Issue while reading

April 1, 2025, 10:10 pm

Hi jagadish gundavarapu, Any update? Thanks, Regards, Veerappan P.

View Article

Forum Post: RE: AM2434: Ether PHY Build Error for single_chip_servo

April 1, 2025, 10:12 pm

Hi, [quote userid="499871"...

View Article

Forum Post: RE: TMS320F28P559SJ-Q1: Edge detection of ePWM for CMPSS

April 1, 2025, 10:13 pm

Hello Stevan, >3. Route SOCA to CMPSS via TRIPSEL Please explain this routing. Our recognisation, SOC is Start Of Conversion of ADC. TRIPSEL can select ADCxEVTy. How can we connnect SOC to ADCxEVT?...

View Article

Forum Post: RE: TMS320F28388D: Implement the CPU Usage % mechanism for C28x CPUs

April 1, 2025, 10:16 pm

Hi Rohit, You can refer to the following page in the C28x Academy : Embedded Real-time Analysis and Diagnostic (ERAD) . There are examples demonstrating the usage of ERAD available in...

View Article

Forum Post: RE: TM4C123GH6PZ: LATCH-UP AND FREEZING OF MICRO DURING ESD

April 1, 2025, 10:27 pm

Hi The test Standard is ISO13766 Part 1 PFB the list of ESD components added in our design based on the type of IO / Function Request you to get back with solution to mitigate this problem. Very are...

View Article

Forum Post: RE: LAUNCHXL-F28P55X: Triggering NMI with External GPIO

April 1, 2025, 10:29 pm

Hi, I have tested this demo can trigger the NMI interrupt, but when test GPIO5 output use the oscilloscope, it showed a waveform like this: I have deleted ESTOP0 before testing, It is not the waveform...

View Article