Part Number: MSPM0G3507 Tool/software: Heyho! I'm working on secondary BSL (secondary_bsl_uart_LP_MSPM0G3507_nortos_ticlang) because I want to change UART-BSL-Pins from default UART0 to UART1. This works with my modifications in "ti_msp_dl_config.h". Now I want to change the invoke pin/deactivate GPIO invoke / change to software invoke. The only place where I found code to modify is the boot_config.h. (L. 63-74) /* Defines for BSL UART and I2C interface pins */ // Werte werden im Typedef Struct BSL_Config BSLConfig gesetzt #define DEF_UART_RXD_PAD (0x16) // PINCM22 #define DEF_UART_RXD_MUX (0x2) // PIN FUNCTION UART0_RX #define DEF_UART_TXD_PAD (0x15) // PINCM21 #define DEF_UART_TXD_MUX (0x2) // PIN FUNCTION UART0_TX #define DEF_I2C_SDA_PAD (0x1) #define DEF_I2C_SDA_MUX (0x3) #define DEF_I2C_SCL_PAD (0x2) #define DEF_I2C_SCL_MUX (0x3) #define DEFAULT_BSL_PIN_INVOCATION_DATA0 ((uint8_t) 0xa8) // 1010 1000 - BSLIVK_LVL = HIGH - BSLIVK_PAD_NUM = 40 (IOMUX PINCM register Wert) #define DEFAULT_BSL_PIN_INVOCATION_DATA1 ((uint8_t) 0x12) // 0001 0010 - BSLIVK_GPIOPORT = Port A - BSLIVK_GPIOPIN = 18 -> PA18 But this is all about the default Configs.. can I nonetheless change these defines or is there any other file or location where I should do my secondary BSL invoke configurations? And on the other side. Every time that I build my project the files "boot_config.c/.h" get re-generated in "Debug"-Folder and all my changes are lost. How can I prevent this from happening? Thanks a lot in advance! Matze
↧