I have a MSP-FET 430UIF USB-Debug-Interface that I am trying to set up using the FET-Pro430 Flash Programmer Lite software. After installing the software (which included installing a USB driver and updating the firmware on the Interface device), when I click "Verify Security Fuse", I get an error that says that the Target Microcontroller is not responding. I'm confident that my microcontroller is functional because we have another MSP-FET 430UIF USB-Debug-Interface in the office (which was installed by someone who is no longer in our office) and this microcontroller responds without error using that other Interface setup. I'm also confident that our physical connections are not the issue because if I use this debugger with the other (working) station's connectors, I get this same error. I feel as if I'm missing something in the installation procedure, and I was wondering if someone could help me troubleshoot the errors I am getting.
↧