Part Number: MSP430FR5964 Hello, After programming the processor by MSP430Flasher through SBW interface I noticed, that device consume few hundred microamps of current. This current flow constantly also if I disconnect MSP-FET from device. Program runs normally. I suspect that SBW interface is not properly released and causes such increased power consumption. Is it possible to disable/release SBW interface without reconnecting MSP-FET again nor powering off device? I was try to do the "software BOR" reset, but it didn't help (PMM_trigBOR from msp library).I also tried to disable JTAG by writing 5555 into jtag_signature and then reseting device, but this idea also failed. Any help? Best regards, Mateusz
↧