Hello! Thank you for the response Below I listed all the ways that I referred from some similar thread but it all failed: - The pins have been configured for SCI_A communication correctly (GPIO29 and GPIO28 for TX and RX, respectively). - Changing the oscillator frequency from 20MHz to 10MHz or use internal oscillator. - The COM port has been assigned correctly as Device Management in Windows shown. (COM3 or COM4, I tried both) And I tried to send data via SCI-A to the Terminal in CCS, the Terminal didn't show anything. The links below are the board and the emulator I used: Please check it for me. Thank you
↧