Hi Suresh, Are you getting this issue for the first time for this particular board? or you ran the code for few times then you are seeing this issue? Error-1170: This is usually caused by either a hardware failure on the board or invalid code on the MCU flash that causes it to reset itself continuously. Have you programmed any code to the flash before? If it is caused by the invalid code, p lease try this procedure to let CPU enter a debug state: Open the target configuration window, and launch the selected the configuration Switch to debug window. Press the reset (nRST) button and hold it. Click “Connect Target” immediately after you release the nRST button. The board should be connected after couple tries. And also refer below threads: (+) TMS570LS3137: Error connecting to the target - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums (+) CCS/TMS570LC4357: "(Error -1170 @ 0x0 Unable to access the DAP." - Tried multiple solutions without success - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums (+) TMS570LC4357: PLL locked after bad code - flash erase problem - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums -- Thanks & regards, Jagadish.
↧