Hi Monika, Please refer to the F28P65x Data sheet, specifically Section 6.12.7 : PD (pin 5) should be connected to the VDDIO supply of the MCU, as this pin is used by the emulator pod to confirm there is good power to the device. F28P65x devices do not support the EMU1/EMU2 signals, so you can follow the datasheet's recommendation to add pull up resistors to these signals. Connect TMS, TDI, TDO, TCK as recommended in the datasheet. For additional information about JTAG pinout, please check out this link -> software-dl.ti.com/.../emu_jtag_connectors.html Best, Matt
↧