Part Number: MCU-PLUS-SDK-AM243X Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hello, I am trying to get the application image verification by bootloader/DMSC to run. A few prerequisites: Using MCU+ SDK for AM243x 9.2.0.50 Using SysConfig 1.20.0 Using custom flash W25Q64JV. Using AM2432BSFFHIALXR Sitara on custom hardware. The issue is: If I set the setting "Disable Auth For Application Image" then it works as intended. But if I uncheck this setting then Bootloader_verifyMulticoreImage() inside Bootloader_parseMultiCoreAppImage() fails. However, I assume that the application image is properly signed by makefile_ccs_bootimage_gen. I have attached a minima example of 3 projects (bootloader, system image and application image). You can check my flash settings there. I have also attached my devconfig.mak. I also tried already a few things like switching "app_degenerateKey.pem" for "rom_degenerateKey.pem" or "custMpk_am64x_am243x.pem" and vice versa etc. and switching GP for HS without success. I would appreciate it if somebody could look over my projects. I tried to keep them as close as possible to the original example projects. Thank you. Kind regards, Martin
↧