Part Number: MSPM0G3507 Tool/software: Howdy! I am attempting to configure my micro for controlling a circuit using the DAC12 connected to the OPA0 using the following settings. The DAC12: The OPA0: I can enable the DAC and OPA0 to operate and disabling their pins drops the voltage to zero, so I know I am not getting supplied voltage from anywhere else, however I am attempting to use the DL_DAC12_output12 ( ) function to manually control the voltage supplied. From what I can gleam from the documentations, supplying a valid value to this function should control the DAC, however I am seeing no change. [ DL_DAC12_output12 (DAC0, config . HeaterV ) where HeaterV is my voltage value 0x4BB ] I am not sure if there is something I am missing about this DAC and OPA0 set up. My pin PA15/19 is floating and set to input, but I'm not sure if that would be the issue. Any help in this would be great!
↧