Part Number: AM2634 Other Parts Discussed in Thread: UNIFLASH , SYSCONFIG Tool/software: Hi teams, I am Working on AM2634-cc and i have a doubt what ever we are Flashing in CCS the Program is not Storing into the flash memory and it will Store on the RAM memory, I need to Load the program directly into the FLASH memory not in RAM. so i did Flashing by Uniflash and UART Bootloader so it is working fine, But my requirement is i need to FLASH the Program Directly into the Flash not in RAM memory, so i did small changes in the Sysconfig. I want the Clear information what are all the Things i need to change in the Sysconfig? I have modified section memory address Initially sections were pointing to OCRAM but I have changed to Flash. But, I got the ERROR Cortex_R5_0: Error Code 30000001 Cortex_R5_0: Run failed... Cortex_R5_0: File Loader: Failed to terminate flash programming: The algorithm failed to flash the data. Power cycle the EVM and try again. Cortex_R5_0: GEL: File: D:\TI_workSpace\gpio_led_blink_am263x-cc_r5fss0-0_nortos_ti-arm-clang\Release\gpio_led_blink_am263x-cc_r5fss0-0_nortos_ti-arm-clang.out: Load failed. Any solution for this? Appreciate your support on this!
↧