The LCD that I currently use is NMTC-S0802XRGHS with the following address to its guide-sheet.
I can show 2 line by 8 character in each line.
The thing is I am using MSP430F47197 and would like to connect it to the LCD.
The issue is even though I know my connection of LCD to the board (hardware-wise), I do not know if the ports are communicating with micro or not?
On the pages 74 and 75, it is said "Function" but I don't know whether I need to use P(O/I) or S which is a pin number.
Let's say E is assigned to the pin P8.2 but this pin has DIR, SEL, LCD Control.
That is why I am a little bit confused. Do you have any experience on this?
The question is how to address the MCU's pins in order to communicate with LCD.
Refer to my previous post, please kindly read it here: