Thank you for the feedback. I do have everything basically working now, but I still feel like I am missing some very fundamental process/procedure for programming and debugging this system efficiently. Here is the sequence that is working for me: 1) Program the Cortex M (CM) 2) Program the C28x 3) Run the C28x (which boots the CM) What I don't fully understand is why programming the CM erases the C28x (probably a check box somewhere that I'm not seeing). In other words I can't reverse steps 1 and 2 above. Also, when I stop both processors why can't I start them back up again? Thanks, Bob
↧