Part Number: TM4C1294NCPDT Hi Team TI, We designed TM4C1294NCPDTI based custom board for our application. We are using XDS110 USB JTAG prob for programming/debugging purpose and CCS studio for compilation, Board is running on TI-RTOS, we are facing below issue while board testing, Issue 1) While programming through JTAG below error occurs very frequently, a) Verification failed: Values at address 0x00007F83 do not match Please verify target memory and memory map : this occurs while programming b) Invalid CIO command (26) in the CIO buffer at address (0x200157A8) was not recognized. Please check the device and program memory maps.: this occurs while programming c) CORTEX_M4_0: Can't Run Target CPU: (Error -2134 @ 0x0) Unable to control device execution state. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 8.2.0.00004) : this occurs once programmed and trying to attempt debug session.Not able to debug properly. JTAG always disconnect. Issue 2) We are using internal phy for ethernet, How to test Ethernet throughput using TI-RTOS, is there any utility tool available? Issue 3) we are unable to set 7.5Mbps speed for UART. How to set UART speed to 7.5Mbps and 15Mbps in TI-RTOS?
↧