Jordan, There is typically no need for a resistor or capacitor on the eCAP's pin. This is only required if the customer is trying to filter noise, even then I would suggest that they use the input qualifier to try and filter the noise. If the edge looks good then you should be OK. If the GPxDAT register latches the value then we can guarantee that the eCAP will also see the rising/falling edge. I do not know of any internal connection between GPIO24 and GPIO68. The fact that changing the state of GPIO68 has an effect on GPIO24 is very strange, but lets not read too much into that yet. It may just be a side effect of a another problem. Regards, Cody
↧